Install UCS File:
- Log in to the Traffic Management Shell (tmsh) by typing the
following command:
tmsh
- Restore the UCS archive file by using the following command syntax,
replacing <path/to/UCS> with the full path of the
UCS archive file you want to restore:
BIG-IP
11.x and 12.x:
load /sys ucs
<path/to/UCS> no-license – for 11.x
load /sys ucs
<path/to/UCS> rma – for 10.x
- Restart the system by typing the following command:
Reboot
NOTES:
By default, the
BIG-IP system saves the UCS archive file with a .ucs extension if you do not include it in the
file name. You can also specify a full path to the archive file, and then the
archive file is saved to the specified location. If you do not include a path,
the file is saved to the default archive directory, /var/local/ucs.
When replacing one
system of a failover pair, F5 recommends that you configure basic networking on
the replacement unit and synchronize the configuration from its peer instead of
restoring the configuration by installing the UCS archive. Because the master
key is shared between units of a redundant pair, the configuration
synchronization process synchronizes the original master key to the newly
installed device.
No comments:
Post a Comment